tag:blogger.com,1999:blog-1592992209402300549.post4021064954866057879..comments2024-03-28T08:06:43.198-04:00Comments on The Silicon Graybeard: Setting Up To Tear Down the G0704SiGraybeardhttp://www.blogger.com/profile/00280583031339062059noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-1592992209402300549.post-53276166025553278152017-01-14T16:34:35.561-05:002017-01-14T16:34:35.561-05:00I just got back from finishing it, and what I did ...I just got back from finishing it, and what I did is similar to what you said, except I cut the webs with a saw. Two saws, actually. I used my reciprocating saw (a battery-powered, Ryobi Sawzall, if you'll pardon that) on the sides that had long access, but the side that has short access (left/right in the pic), I used my jig saw. Cut through it exceptionally easily. Drilling the holes was harder. There I used an AC plugin drill instead of my battery-powered drill and the difference was night and day. The AC powered drill is a HP, actually 1-1/4 by the label. <br /><br />Haven't done that section on the underside, yet. <br />SiGraybeardhttps://www.blogger.com/profile/00280583031339062059noreply@blogger.comtag:blogger.com,1999:blog-1592992209402300549.post-12287161627872655012017-01-14T15:35:54.954-05:002017-01-14T15:35:54.954-05:00Hmm. Idea-
Strike a line, and centerpunch for 1/4...Hmm. Idea-<br /> Strike a line, and centerpunch for 1/4" holes leaving 1/32" between hole edges.<br />Then break out the webs with a punch. <br />On the flange section, where the cut does not go though, drill the waste with a larger drill, and clean it up with a 1/2" end mill in the drill press? <br /> ravennoreply@blogger.comtag:blogger.com,1999:blog-1592992209402300549.post-59306870232775265692017-01-14T10:04:18.504-05:002017-01-14T10:04:18.504-05:00Comment deleted for not being even remotely relate...Comment deleted for not being even remotely related to anything I blog about. SiGraybeardhttps://www.blogger.com/profile/00280583031339062059noreply@blogger.comtag:blogger.com,1999:blog-1592992209402300549.post-62640618752230378002017-01-14T04:24:29.180-05:002017-01-14T04:24:29.180-05:00This comment has been removed by a blog administrator.Anonymousnoreply@blogger.com